Aluminum Expansion Joints

Arfen aluminum expansion joints are manufactured from high quality aluminum frame and sealed rubber. The Arfen aluminum series allows the joint to be deformed and stretched. These expansion joints are equipped with surface gutters that allow for convenient water drainage. With its special design, it provides little noise when passing over vehicles. The edge profiler is manufactured from specially drawn aluminium and carries heavy traffic loads. Profiles have a yield strength of 275 MPa and a tensile strength of 300 MPa. The sealed rubber is strong against grease, oil, chemical and resistant to UV rays, land and salt. In addition, two types of rubber seals can be selected as desired in these aluminium expansion joints. This system is manufactured under the control of our qualified engineers in high quality conditions in our factory. Arfen BE aluminium series bridge expansion joints guarantee a long-term solution to corrosion. Expansion joints of different sizes are connected to the superstructure by mounting on both sides using corrosion-resistant galvanized anchor bolts and chemical anchors suitable for absorbing elastic reactions, mechanical vibrations and other movements of the structure. M20 bolts are used in the anchorage process. Repairs and replacement of old expansion joints are very easy. Without breaking concrete you can change expansion joint.

Recommend areas to use;

- Sealing of bridge joints

- Sealing of parking lots

- In new build or repair

Properties :

• Easy montage

• Gasket type can be selected from 2 different models

• Movement capacity up to 120 mm

• M20 galvanized anchors are used

• Watertight joint system

• Frames are produced from pure aluminum

• It is finished flat with the traffic surface and provides a smooth transition over the expansion joints.

• Walkway covering plates are provided if necessary.

• Gaskets can cover vertical alignment and limited tilt angle.

Get detailed information about other products; www.arfen.com